| | | |

Jewelry for your Garden

This Post May Contain Affiliate Links. Please Read my Disclosure Policy.

This is a fun trash turned into treasure something useful project.  I call my creation “Jewelry for the Garden”. 

I came up with this idea for DIY garden markers after my hubby asked me if I could make something to mark the veggies and herbs that he recently planted in our garden.  I could have used a number of things as markers – the stamped spoon idea is so cute, but I don’t have any extra spoons or a stamping set.  Tongue depressors or Popsicle sticks – they break apart.  I could have went to a garden shop and bought some, but I don’t want to spend money on something I knew I could make.   So I looked around the house and found these 3 items to make my garden markers – a wire hanger, an OJ can lid, and a few beads.

Wire hangers from the dry cleaner, orange juice can tops and bottoms, and a few beads from my collection.

Garden Markers made from Orange juice cans

Cost:  Nothing     Time to Complete: 15 minutes =  A Happy Hubby   He would have been fine with just the OJ lids on the hanger, but I had to add a little style to them.

Garden markers made form OJ can lids

How To Make Garden Markers Using Juice Can Lids and Wire

These garden markers are very easy to make.  The hardest part is waiting until you have collected enough OJ cans to make enough markers for all the plants you want to mark in your garden.

1.  Pull the wire part of the hanger from the cardboard tube.  One on each side.  This will be the hook on the top of the stake.

Garden Markers made from Orange juice cans - full tutorial

2. Untwist the hook part of the hanger.

How to make garden markers from OJ can lids

3. Open up the hook, by spreading the two wires apart.

Step by step tutorial on how to make garden markers from oj cans

4.  Cut in the center with wire cutters.  You have just created 2 stakes to hang the OJ lids on.

OJ can lid garden marker tutorial

5.  Press the smaller hook end back a bit with your fingers so that it is closer to the wire behind it.

OJ can Lid Garden Marker tutorial

6.  Mold the bigger hook end with your hands so it resembles the ones shown in the photo below.  This end will go into the ground, so it does not have to be perfect.  It will give the stake support.

OJ can lid garden marker tutorial

7.  Optional:  Spray paint silver to match the OJ lid.

OJ can lid garden marker tutorial

8.  If you have a Dremel drill – drill 2 holes in an OJ lid – one at the top and another at the bottom.  Make sure the bottom hole is close to the edge of the lid so you will be able to thread a jump ring through it.  I placed mine right in the lid’s groove.  If you don’t have a drill, an awl and a hammer will also make a hole.


OJ can lid garden marker tutorial

9.  Add some pretty beads to a jump ring and attach to the lid. I was going for an all green look so the markers would look nice, but would blend in with the garden at the same time.

OJ Can Garden Markers

10.  I tried using a stamping set to mark each lid, but the metal is too soft, so I used permanent markers.  If you want to stamp the names on each marker – use tin can lids that are opened with a can opener that doesn’t leave the edges sharp.  Most tin can lids are bigger and have ridges in them.  I like the OJ lids – they are smooth.

Sharpie Markers

11.  Push the larger hook end into the dirt and never again forget what you planted.  The beads and the lids move in the breeze and jangle a bit- it might scare the birds and other animals who may decide to make a feast out of your garden.

DIY Garden Marker from recycled OJcan lids

 Have you made anything out of trash lately that you would like to share?  I always love to see clever ways to re-purpose items that we would normally toss in the trash. I have made a few different garden label variations from household items in this post about garden markers.


Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.


  1. Hi Rory –
    I was so happy to link a project to your site that I actually used a tool to create, – a Dremel drill. My hubby bought it for me a couple of years ago for my birthday.
    I love salsa – with chips and margaritas. I hope you get a bumper crop this year.

  2. I did the same thing! Used the Big Bite (cropodile) to punch it – punched through like butter!

    1. Hi Deanna-

      You are the second person who mentioned the Cropodile. I didn’t know what it was and Googled it. Pretty cool tool. Thanks for sharing the tip.

  3. I searched the web for an idea like this a few weeks ago — but couldn’t find one as cute as this! I even have the juice tin lids already on hand! BTW — a Cropodile will punch the holes just fine, too:)

    1. I just looked up what a Cropodile was – I think I need one. Since I have never made a scrapbook, I also need to get get informed on all these scrapbooking tools that can be used for other applications.

    1. Hi Deb-
      Ed has a whole list of markers he would like up in the veggie garden – I didn’t make all of them with dangles. The herbs are planted closer to the house, so I wanted them to look pretty.